What led to CNC lathe limit alarm

With the constant innovation of science and technology, the technology used on the CNC lathe has also started to constantly improve. In the early years, the technology concerned with the research and development of such devices was only the density of precision, the time used in the production of the product, In the moment with the improvement of these basic technologies, more, enterprises in the production of various types of products is more concerned about how to do a good job of product maintenance. Once out of range work immediately alarm to ensure that users can shut down the lathe to avoid the lathe encountered greater harm, resulting in the maintenance can not be used.

It is precisely because of this reason, in the present many CNC lathes are used limit alarm this way, then this method is what causes it? The actual use of the process can be found in the probability of occurrence of this situation is still relatively high, the reason why such a situation occurs, the main reason is that external components are subject to environmental impact, such as physical impact, when the machine is subject to collision After that, or there is a relatively serious corrosion, friction will trigger the limit alarm this situation. Not only this, but also for example when the limit switch itself can not be reset after damage, this situation can occur, in short, cause for this situation is a wide range of problems.

    Of course, in addition to the above reasons there are many. But in fact can be divided into the following points, the first is due to the operation of nonstandard and according to the limit alarm, in which case due to misoperation led to the alarm situation, the impact on the equipment is relatively small, as long as the first A time off to avoid the loss of enlargement, after the occurrence of this situation, the use of machine tool over its own function can be completed to solve the problem, the relative solution is relatively simple, you want to avoid the occurrence of such problems should be on-the-job staff Conduct training on related operations and strictly enforce operating rules in accordance with the rules and regulations. This can fundamentally put an end to this situation, there are data that more than 60% limit alarm is due to misoperation causes, so good operator training is very crucial.

    The second case comes from the physical damage to the CNC lathe manufacturers products, this situation in most cases is the processing of various accessories did not pay attention to the reasons for the site, processing parts on the machine itself caused the collision, and the collision relative More serious, this situation limit alarm will occur, you want to prevent this from happening, for the construction of external environment facilities must pay attention to, the reason why there will be such a situation in most cases because of the working environment is more narrow, expand Production workshop space or the density of the machine is reduced, so that we can effectively avoid such problems. The third case of machine tool system was outside interference caused by data loss, in most cases is the impact of natural conditions, is beyond the control of manpower, for example, in rainy weather thunder and lightning on the machine have an impact, loss of parameters or parameters Changes in the face of such problems can not blindly boot to work, even in the absence of fault conditions must also be the machine overhaul to find out if there are hidden problems, to avoid serious problems. Careful attention to these details can effectively circumvent the limit alarm situation.